Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing Spark Plugs on the Toyota Highlander

Model: Toyota Highlander Xu50 - Years: 2014, 2015, 2016, 2017, 2018, 2019
Part: Spark plugs

See other generations:
Video tutorial

Before starting the spark plug replacement on the Toyota Highlander, secure the vehicle on a stable and safe ramp or flat surface. Take this precaution, which should be observed in any maintenance operation on any vehicle, to ensure the operator's safety.

Now, open the front bonnet of the engine compartment and locate the spark plug to be replaced. Disconnect the electrical connector and, after unscrewing the power supply tube, use the appropriate spanner to unscrew the spark plug and replace it with a new one. Repeat the process for each of the spark plugs to be replaced.

Three of these are positioned behind the engine block, and to access them, it is necessary to remove the connections of the air ducts.


Updated on 3 May 2026 by ScegliAuto


Related tutorials

How to Replace the Spark Plugs on a Toyota Highlander V6
How to Replace the Spark Plugs on a Toyota Highlander V6
Toyota Highlander (2001-2007 / Xu20) This guide shows how to remove and replace the spark plugs in the engine of a Toyota Highlander V6 by following these simple steps. First, open the b…
How to Reset the Service Light in a Toyota Highlander?
How to Reset the Service Light in a Toyota Highlander?
Toyota Highlander (2020-2026 / Xu70) In this video, see how to reset the maintenance light in a Toyota Highlander. This simple operation should only be performed after completing all sch…
How to Set the Time on the Toyota Highlander
How to Set the Time on the Toyota Highlander
Toyota Highlander (2020-2026 / Xu70) Below are the instructions that will allow you to set the clock on the Toyota Highlander in simple steps. First, get in the vehicle and turn on the i…

How to Open the Bonnet on the Mitsubishi L200?

In this tutorial, you will see how to open the bonnet on the Mitsubishi L200, a very simple operation that follows the standard procedure. First, open the vehicle and go to the driver's side, then locate the lever at the lower outer area, just in front of the pedals, and pull it. Next, position yourself in front of the bonnet, locate the second lever above the Mitsubishi logo, and push it to the right, releasing the latch. At this point, you can fully lift the bonnet and secure it with the prop rod.

Watch the video!


by ScegliAuto

More videos