Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Stick Side Lower Spoilers to Your Car

Model: (Various brands) Various
Part: Checks and maintenance

Let's see how to stick side lower spoilers to your car. Obtain the aftermarket or original brand spoilers (with adhesive strip) that will go under the side bodywork. Here’s the procedure: clean the lower bodywork of the car thoroughly (use a non-corrosive cleaning product) with a cloth, then take measurements with a tape measure and start peeling off the adhesive strips as shown in the video; stick each piece onto the side plastic (cut off the excess after sticking). Double-check the correct fitting of the pieces.

Updated on 10 March 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Reattach the Interior Rear View Mirror
How to Reattach the Interior Rear View Mirror
(Various brands) Various The procedure for reattaching the rear view mirror on a vehicle (in this case, a van) is the same for all vehicles. First, clean the area of the glas…
Replacing the Mass Air Flow Sensor in Your Car
Replacing the Mass Air Flow Sensor in Your Car
(Various brands) Various Let’s see how to replace the mass air flow sensor in your car. Lift the bonnet and secure it, then use a screwdriver to unscrew the locking bolts of …
How to Glue a Rear View Mirror to a Car
How to Glue a Rear View Mirror to a Car
(Various brands) Various To glue the rear view mirror, the video uses a specific adhesive from "Loctite" which includes a mesh and a cloth; clean the area where the mirror su…

    Frequently Asked Questions

    • Vari - What does it mean when the message "insp" appears on a car? Read answer
    • Vari - Why doesn't the Becker Map Pilot start? Read answer
    • Vari - What problems does the Kymco Downtown 300i have? Read answer

How to Bleed the Clutch on a Renault Clio?

To bleed the clutch on a Renault Clio, open the bonnet to access the components located in the engine bay: here, you will need to undo the screws that secure the battery in its housing, the intake manifold, and the coolant reservoir. This will allow you to locate the pipe through which the brake fluid flows: by inserting the other end of the pipe into a container, you can press the clutch pedal to expel all the fluid until it fills the container.

Watch the video!


by ScegliAuto

More videos