Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. (Various brands)
    3. :
  3. Various
    4. : How to mount a Fabbri windshield on an Aprilia

(Various brands) Various - Video tutorial

Model: (Various brands) Various
Part: Windshield
Operation: How to mount a Fabbri windshield on an Aprilia

If we intend to mount a windshield ourselves on our scooter we can follow the instructions below and refer to the video. Identify the various components of the assembly kit and take the fixing bolt to the bracket on which we are going to insert the gasket and the block for fixing it on the scooter. Furthermore, the finishing rubber covers and spacers are also present in the kit. First of all disassemble the small fairing that comes with the scooter and mount the fairing supplied with the kit, then screw it with the through support brackets, take the windshield and tighten the support pins around the support rod.


Posted on 8 April 2023 by ScegliAuto

Other guides that may interest you

    Frequently Asked Questions

    • Vari - How much does the windshield of the Kymco 125 People S cost? Read Answer
    • Vari - How can a windshield seal be repaired? Read Answer
    • Vari - What is the cost of the windshield? Read Answer
    • Vari - How much does it cost to change the car windshield? Read Answer
    • Vari - How much does it cost to replace the windshield? Read Answer
    • Vari - Where does the p of beginner stick to? Read Answer
    • Vari - Where does the p of beginner stick to? Read Answer
    • Vari - How much does the windshield seal cost? Read Answer
    • Vari - How much does the windshield cost? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos