Do it yourself
Frequently asked questions about cars and motorcycles

How to Replace the Rear Light on a Piaggio Vespa GTS 300

Model: (Various brands) Various
Part: Tail light

If you want to replace the rear light on this scooter model, the description and video provided will give you all the information and useful steps to carry out this operation correctly. First, assemble all the components of the rear light on the workbench, placing the gasket all around. Then, take a screwdriver and unscrew the fixing screw located underneath the rear light. Unclip the optical group by pulling it towards you and remove it from the bodywork, then disconnect the rear power connector. Next, take the new light and position it at the back, reconnect the electrical connector, and secure the screw again.

Updated on 29 July 2026 by ScegliAuto

Video tutorial

Related tutorials

(Various brands) Various As shown in the video, you need to purchase an original Piaggio top box for the Vespa GTS 300. After fitting the support for the top box, proceed to …
(Various brands) Various In this model, you will learn how to charge the battery of the Vespa 300 GTS. Before charging the battery, insert the key and try to start the engine…
(Various brands) Various If you need to replace the fuel filter on this scooter, you can find instructions in this video and the description below. First, flip up the seat an…

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos