Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Wheel Bearing Without Removing the Hub

Model: (Various brands) Various
Part: Bearing

To change the bearing without removing the hub, apply the handbrake and put the car in first gear, then loosen the hub nut as shown in the video. Continue by lifting the car and removing the wheel; this will allow you to detach the retaining clip of the brake pads and remove the brake caliper and pads. Proceed by sliding the handle of the hammer against the stop to detach the bolt of the lower ball joint. Now you can move on to fitting the new bearing, starting with the installation of the lower ball joint. Position the bearing on the hub axle and reconnect the second circlip on the ball joint. Reattach the support and refit the wheel.

Updated on 19 August 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacing the Front Wheel Bearing
Replacing the Front Wheel Bearing
(Various brands) Various Let's look at replacing the front wheel bearing of the car. Lift the car with a jack, remove the wheel to access the wheel hub. Undo the bolts of the…
How to change wheel bearings
How to change wheel bearings
(Various brands) Various In this video, see how to replace a wheel bearing. It is one of those parts that you immediately notice needing replacement due to the continuous noi…
How to Change the Front Wheel Bearing
How to Change the Front Wheel Bearing
(Various brands) Various In this tutorial, you will see how to replace the front wheel bearing on a car. First, engage the handbrake and put the car in first gear, then loose…

Other guides you may be interested in

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos