Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Remove the Rubbing Noise from Door Seals

Model: (Various brands) Various
Part: Checks and maintenance

While driving, have you noticed annoying noises coming from the doors when you drive over bumps or potholes? Today, we will reveal the source of these noises and how to eliminate them. The origin of these annoying sounds is due to the rubbing of the door seals, which deteriorate over time and with rain. To remove these noises, use silicone oil. Simply spray the oil over the entire surface of the seal using the nozzle of the can. Once this operation is performed on all four doors, you will no longer hear the noises.

Updated on 12 September 2026 by ScegliAuto

Video tutorial

Related tutorials

How to eliminate brake noise in your car?
How to eliminate brake noise in your car?
(Various brands) Various It does not happen often, but it may occur that you hear noise when braking with your car, particularly a squeal. In the attached video, you can find…
A temporary solution to the squeaking of the serpentine belt.
A temporary solution to the squeaking of the serpentine belt.
(Various brands) Various In this video we see an example for those cases where the service belt squeaks during the friction of the first few minutes during start-up, on cold …
What do the seals of a used car reveal
What do the seals of a used car reveal
(Various brands) Various In this video we see what the seals of a used car can tell us about its age and wear. We see an example with a German car, therefore with good qualit…

    Frequently Asked Questions

    • Vari - What does it mean when the message "insp" appears on a car? Read answer
    • Vari - Why doesn't the Becker Map Pilot start? Read answer
    • Vari - What problems does the Kymco Downtown 300i have? Read answer

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos