Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. (Various brands)
    3. :
  3. Various
    4. : How to repair a cigarette burn on the upholstery

(Various brands) Various - Video tutorial

Model: (Various brands) Various
Part: Seat
Operation: How to repair a cigarette burn on the upholstery

Let's see how to repair a cigarette burn on a car seat. Insert a piece of non-stick fabric into the burn hole to prevent the glue from sticking to the sponge padding, fill the hole with liquid glue, sift some fiber flock into a container, put half of it in a pump and mix the other half with powdered glue, mix well and fill the hole where we put the liquid glue using a spatula. Dry with an iron. Masking the hole with paper, spray adhesive and then fiber, using the pump, dry with the iron. Repeat this last sequence once more before finishing the job.


Posted on 15 April 2024 by ScegliAuto

Other guides that may interest you

    Frequently Asked Questions

    • Vari - How to open the seat of a scooter? Read Answer
    • Vari - How to insert the seat covers? Read Answer
    • Vari - How much does it cost to reupholster the seats? Read Answer
    • Vari - Why are heated seats not working? Read Answer
    • Vari - How do you open the compartment under the motorcycle? Read Answer
    • Vari - Why doesn't the electric seat work anymore? Read Answer
    • Vari - What to do if the car seat does not slide? Read Answer
    • Vari - How much does it cost to upholster a rear seat? Read Answer

Replace the steering angle sensor on the Volkswagen Golf 5

When the steering angle sensor malfunction warning light comes on, it may need to be replaced as follows: first remove the steering wheel and the lower steering wheel guard by removing the three fixing screws. The steering sensor is located just below the steering column. To release it you need to have a small screwdriver and insert it into the hole on the front, push the screwdriver all the way down until the clips at the bottom are released. Next, pull down on the back of the card containing the sensor and disengage it from the steering column. At that point take the new card and reposition it, after which proceed backwards to reassemble the various components.

Watch the video!


by ScegliAuto

More videos