Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to replace the cabin fan

Model: (Various brands) Various
Part: Blower motor

In this video we see how to replace the cabin fan, which is almost always located on the passenger side. In this case, it is even visible, just remove the three screws. Our youtuber recommends marking the position of the fan with a marker, so that you can put it back in place later. The resistor is right below and secured with two screws: we remove it by unscrewing the two lower screws. (Remember that if the resistor no longer works, the fan only works at maximum speed). He did a check with the Ohm tester to see if the fan motor was still efficient, with a positive result. Instead, the resistor needs to be replaced. We replace the resistor with the new one and reassemble the fan and perform a test run; now the fan works at intermediate speeds as well. We can put everything back in place. Operation completed.

Posted on 17 April 2024 by ScegliAuto

Video tutorial

Related tutorials

How to Test the Cabin Heater Fan
How to Test the Cabin Heater Fan
(Various brands) Various In this video tutorial, you will learn how to test the cabin heater fan of a generic car. Heating issues are not always caused by the fan: therefore,…
How to Replace the Cabin Fan
How to Replace the Cabin Fan
(Various brands) Various First, locate where you need to perform the operations. The motor to be replaced is positioned behind the glove compartment in front of the front pas…
Testing the Cabin Fan of a Car
Testing the Cabin Fan of a Car
(Various brands) Various Today, you will learn how to test the cabin fan of a generic car in simple steps. First, you should remove the fan, which is usually found inside the…

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos