Do it yourself
Frequently asked questions about cars and motorcycles

How to disassemble the roof lining of a Volkswagen Polo

Model: Volkswagen Polo Polo 5, Polo V, MK 5, MK V, 6R - Years 2009-2017
Part: Checks and maintenance

Through this very useful guide, we can see how to remove the roof lining of a Volkswagen Polo 6R. Let's start by removing the four handles above the doors and the two front sun visors, then we continue by removing the interior light fixture following the procedure shown in the video. Once that is done, using a plastic lever to avoid damaging the interior of the car, we start removing all the plastic panels of the pillars, finally we lower the interior roof of the car and gently remove it from the rear trunk of the vehicle.

Posted on 24 August 2024 by ScegliAuto

Video tutorial

Related tutorials

Volkswagen Polo (2001-2009 / MK IV, Polo IV, Polo 4, MK 4, 9N) In this tutorial, you will see how to remove the headlining in a Volkswagen Polo, a very simple and quick operation. First, go inside the cabin, then…
Volkswagen Polo (2009-2017 / Polo 5, Polo V, MK 5, MK V, 6R) Want to replace the cover panel of the Volkswagen Polo? Here’s how to remove the cover panel from under the roof of the Polo. Remove the side handles…
Volkswagen Polo (2009-2017 / Polo 5, Polo V, MK 5, MK V, 6R) Today we will see the process of disassembling and replacing the antenna of the Volkswagen Polo car radio, in simple steps. First, we open the rear t…

    Frequently Asked Questions

    • Polo 2009-2017 - Where are the fuses located in the Volkswagen Polo? Read answer
    • Polo 2017-2025 - Message "Leave the vehicle only in position P" in the Volkswagen Polo, what does it mean? Read answer
    • Polo 2017-2025 - Where is the temperature sensor of the Volkswagen Polo located? Read answer

How to Repair the Key Spring of the Peugeot 207?

Over time, frequent use of the key's flip mechanism in the vehicle, dozens of times a day, inevitably leads to wear of the internal spring. As shown in this video, replacing the spring is quite simple and takes little time. After opening the casing halfway, first position the key, then the spring housing, and finally insert the spring into the previously mentioned housing. Close the casing by rotating it clockwise, ensuring all components fit perfectly, and test the key's flip mechanism.

Watch the video!


by ScegliAuto

More videos