Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Volkswagen
    3. :
  3. Passat
    4. : How to change the water temperature sensor of the Volkswagen Passat 1.8T

Volkswagen Passat - Video tutorial

Model: Volkswagen Passat 3BG, B5 - Years 1996-2005
Part: Coolant temperature sensor
Operation: How to change the water temperature sensor of the Volkswagen Passat 1.8T

Let's see in this guide the instructions that will allow us to remove and replace the coolant temperature sensor of the Volkswagen Passat 1.8T. First we open the engine hood and begin to locate our coolant sensor, which we find on the top of the engine compartment and behind the block; after which we remove the plastic protection of the motor and we go to unscrew the fixing screw of the bulb sensor, disconnecting the electrical connector to remove it, as shown in the video. Now let's replace the sensor with the new one and reassemble everything!


Posted on 21 April 2024 by ScegliAuto



Water temperature sensor replacement.
Volkswagen Passat (1996-2005 / 3BG, B5) Open the hood and locate the temperature sensor located under the windshield. Remove the two hose clamps placed on the water duct to be able to remov
Cooling water temperature thermostat replacement.
Volkswagen Passat (1996-2005 / 3BG, B5) Open the bonnet and disconnect the negative pole of the battery to work safely. Raise the car on the bridge. The sensor is located on the engine bloc
Replacing the coolant temperature sensor
Volkswagen Passat (1996-2005 / 3BG, B5) In this video the coolant temperature sensor is changed to a Volkswagen Passat. It is not a very simple operation since the sensor is positioned in a

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos