Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacement of Front Suspension Springs

Model: Volkswagen Golf Golf 5, MK 5, Golf V - Years: 2003, 2004, 2005, 2006, 2007, 2008
Part: Suspension system

See other generations:
Video tutorial

The breakage of the front suspension spring is a rather unusual circumstance; in any case, to replace it, it is first necessary to disassemble the suspension itself and have the appropriate clamps to compress the spring. In the video, the suspension has been removed complete with hub and brake disc, therefore the complete brake caliper support, speed and brake wear sensors, the tie rod from the steering rack, and the link of the suspension wishbone, as well as the shock absorber support itself, have been disconnected.

Once the suspension is extracted, simply compress the spring, remove the upper shock absorber mount, and take out the spring itself. Then compress the new spring, insert it into the shock absorber, reassemble the mount, and release the spring.

Finally, proceed in reverse for the installation of the suspension.


Updated on 11 February 2026 by ScegliAuto


Related tutorials

Replacement of Rear Suspension Springs
Replacement of Rear Suspension Springs
Volkswagen Golf (1997-2003 / Golf IV, Golf 4, MK 4) Replacing the rear suspension spring is relatively straightforward compared to the front suspension, as the spring and damper are not co-axial but se…
Front Shock Absorber Spring Replacement
Front Shock Absorber Spring Replacement
Volkswagen Golf (2003-2008 / Golf 5, MK 5, Golf V) Lift the vehicle on a hoist and remove the front wheel; disconnect the plastic link from the suspension wishbone, free the shock absorber from the ca…
Replacement of Front Suspension Wishbone
Replacement of Front Suspension Wishbone
Volkswagen Golf (1997-2003 / Golf IV, Golf 4, MK 4) The front suspension wishbone consists of two elements: the triangular-shaped wishbone itself, which has two silent blocks for attachment to the chas…

How to Open the Bonnet on the Mitsubishi L200?

In this tutorial, you will see how to open the bonnet on the Mitsubishi L200, a very simple operation that follows the standard procedure. First, open the vehicle and go to the driver's side, then locate the lever at the lower outer area, just in front of the pedals, and pull it. Next, position yourself in front of the bonnet, locate the second lever above the Mitsubishi logo, and push it to the right, releasing the latch. At this point, you can fully lift the bonnet and secure it with the prop rod.

Watch the video!


by ScegliAuto

More videos