Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Volkswagen
    3. :
  3. Polo
    4. : How to replace the front headlight of the Volkswagen Polo.

Volkswagen Polo - Video tutorial

Model: Volkswagen Polo Polo V, MK V, 6R, Polo 5, MK 5 - Years 2009-2017
Part: Headlight
Operation: How to replace the front headlight of the Volkswagen Polo.

In this short video tutorial, we can see how to remove and reinstall the front headlight of a fifth generation Volkswagen Polo 6r, produced from 2009 to 2017. First, we need to open the engine hood. Now, let's unscrew the two screws located above the headlight that hold it in place. Once this is done, we remove the headlight by pulling it towards us and then disconnect all the wiring of the bulbs to completely remove it. To reinstall it, we need to perform the procedure in reverse, but be careful to insert the headlight by aligning it with the specific guides located on the bumper, which are responsible for properly aligning the headlight in position.


Posted on 20 July 2023 by ScegliAuto

    Frequently Asked Questions

    • Polo 2001-2009 - How do you replace the front headlight of the Volkswagen Polo 8? Read Answer
    • Polo 2001-2009 - How much does the right headlight of a Volkswagen Polo cost? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos