Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Rear Brake Rotors on a Volvo XC90

Model: Volvo Xc90 MK 1 - Years: 2002, 2003, 2004, 2005, 2006, 2007, 2008, 2009, 2010, 2011, 2012, 2013
Part: Brake rotors

See other generations:
Video tutorial

This guide will show the complete procedure for replacing the rear brake rotors on a Volvo XC90. Note that this guide is not valid for models after 2014. To proceed, follow these steps: 1. Lift the vehicle using a jack; 2. Remove the rear wheels with a power drill; 3. Remove the brake caliper spring and caliper using a 7 mm socket and a 13 mm wrench; 4. Remove the brake rotor with a 10 mm socket and a few moderate taps with a hammer, then carefully clean the rotor mounting surface; 5. Install the new replacement components by following the previously described steps in reverse order.


Updated on 29 May 2026 by ScegliAuto


Related tutorials

Replacing Rear Brake Rotors and Pads
Replacing Rear Brake Rotors and Pads
Volvo Xc90 (2002-2014 / MK 1) To facilitate the replacement of the rear brake rotors and pads, lift the vehicle on the lift and remove the rear wheel; take off the plastic protect…
How to Adjust the Parking Brake on a Volvo XC90?
How to Adjust the Parking Brake on a Volvo XC90?
Volvo Xc90 (2002-2014 / MK 1) To adjust the parking brake on a Volvo XC90, remove the protective panel on the left side of the center tunnel. Access this panel from the driver's f…
How to disassemble the rear light of the Volvo XC90
How to disassemble the rear light of the Volvo XC90
Volvo Xc90 (2015-2026 / MK 2) Today's instructions will show us how to disassemble and replace the rear light and its bulbs on the Volvo XC90. First, let's open the rear hatch of …

How to reset the Service light on a 2019 Jeep Renegade?

The Service light, depicted as a yellow spanner, illuminates as scheduled to remind the driver that it is time for scheduled maintenance. This means that the set mileage has been reached, or the expected time has passed. The procedure involves turning on the instrument cluster, pressing the accelerator three times, and then turning off the ignition. After this, keep the brake pressed, turn the ignition back on, and then turn it off again. Upon the next ignition, you will notice that the light has been reset.

Watch the video!


by ScegliAuto

More videos