Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Acura
    3. :
  3. Tlx
    4. : How to change the oil and oil filter on your Acura Tlx

Acura Tlx - Video tutorial

Model: Acura Tlx MK 5 - Years 2015-2020
Part: Engine oil
Operation: How to change the oil and oil filter on your Acura Tlx

To change the oil and oil filter on the Acura Tlx we start by opening the engine hood, lift it up, open the oil filler cap, go under the car, remove the oil pan protector in aluminum by unscrewing the screws, with a socket wrench we unscrew the oil drain bolt, let the oil drain by placing a container underneath, finally we clean the oil drain bolt by screwing it back in and tightening it at a pressure of 30 ft/lbs , not before having given a clean in its seat. Then, always under the car, with a special key we unscrew the oil filter, let the oil drain by placing a container underneath, take the new oil filter, spread new oil on the oil filter gasket new and screw it back on after having cleaned its seat, then put the aluminum oil sump protection back on by tightening the screws. Now we can go to the top of the car engine, remove the oil filler cap, pour the liters of oil indicated by the house; when we are approximately on the liters indicated, remove the oil control dipstick, reinsert it and extract it again to check the oil level, where if the level is on the max the quantity of oil is fine otherwise carry out a top up. Finally let the engine run for a few minutes.


Posted on 20 December 2022 by ScegliAuto

Other guides that may interest you

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos