Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to replace the headlight bulb on an Aston Martin DB9?

Model: Aston Martin DB9 MK 1 - Years: 2004, 2005, 2006, 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2015
Part: Headlight bulb

Video tutorial

To replace the headlight bulb on an Aston Martin DB9, loosen the bolts securing the front wheel on the side of the bulb you want to replace: by removing this wheel, you can then proceed to loosen the screws securing the corresponding wheel arch. This can now be removed to access the inside of the headlight: here, you can disconnect the connector and pull out the bulb.

This can now be removed from its housing and replaced with a new spare part, reassembling all removed components.


Updated on 13 September 2026 by ScegliAuto


Related tutorials

How to Replace the Front Brake Pads on the Aston Martin DB9
How to Replace the Front Brake Pads on the Aston Martin DB9
Aston Martin DB9 (2004-2016 / MK 1) Briefly, here are the instructions that will allow you to remove and replace the front brake pads (the same applies to the rear ones) on the Aston Ma…
How to Replace the Battery in an Aston Martin DB9
How to Replace the Battery in an Aston Martin DB9
Aston Martin DB9 (2004-2016 / MK 1) This guide shows how to replace the battery in an Aston Martin DB9. The first step is to move the passenger seat forward and remove the rear seat bas…

Other guides you may be interested in

How to Extract the Spare Wheel from a Mercedes Vito

The spare wheel of a Mercedes Vito is located underneath the vehicle, just below the rear boot. This video demonstrates how to extract the wheel from its compartment. First, open the boot and locate the tools provided with the vehicle to release the wheel; these can be found in a compartment on the right side of the boot. As shown in the video, use the supplied screwdriver to remove the cover cap from the hole where you will insert the socket spanner; this hole is located beneath the rubber seal above the rear bumper. Insert the spanner and attach the extension to allow you to turn it and lower the wheel from under the floor. Finally, detach the pin that allowed the wheel to lower and proceed to extract it from under the vehicle.

Watch the video!


by ScegliAuto

More videos