Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Audi
    3. :
  3. A6
    4. : Infiltration of water in the passenger compartment

Audi A6 - Video tutorial

Model: Audi A6 MK 2, C5 - Years 1997-2004
Part: Bodywork
Operation: Infiltration of water in the passenger compartment

If the passenger compartment is transformed into a small swimming pool, the cause could be the obstruction of the drain hose located in the compartment of the ventilation grilles. To remedy this, it is necessary to access the bonnet and remove the cover from the air intakes. The battery that must be removed is installed in this compartment. First disconnect the negative pole and then the positive pole then remove the sealing screw and remove the battery. Remove the battery holder bolts and take it off. Under the battery holder there is the pipe that discharges the rainwater to the outside. This tube due to dirt, earth, leaves etc. It tends to become clogged and therefore needs to be freed to allow the water to flow out. To remove the water present in the passenger compartment, it is strongly advised not to make a hole in the floor but to use a suitable liquid aspirator.


Posted on 28 June 2023 by ScegliAuto



How do you replace the Audi A6 water pump?
Audi A6 (2011-2018 / C7, MK 4) To be able to replace the Audi A6 water pump, you need to open the hood, in order to have access to the components inside the engine compartment. It
Cabin air filter replacement
Audi A6 (1997-2004 / MK 2, C5) The passenger compartment air filter seat is located immediately under the windscreen on the passenger side: in order to reach it, it is therefore ne
How do you deactivate the passenger airbag on the Audi A6?
Audi A6 (2004-2012 / C6, MK 3) To deactivate the passenger airbag of the Audi A6, you need to open the glove compartment located on the front passenger side. Inside, in the upper l

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos