Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Disassembly and Replacement of Water Pump

Model: Audi A6 MK 2, C5 - Years: 1997, 1998, 1999, 2000, 2001, 2002, 2003, 2004
Part: Pump

See other generations:
Video tutorial

Open the hood and remove the protective covers of the timing belt located at the front of the engine; remove the timing belt tensioner to release the belt from the pulleys. Then, unscrew the mounting bolts of the water pump, pull it out from its seat, and carefully clean the mating surfaces to ensure a perfect seal for the gasket.

Next, install the new pump with the corresponding gasket (it is also suggested to apply gasket sealant on the gasket) and tighten the mounting bolts. Reinstall the timing belt on the respective pulleys and the tensioner, paying attention to the timing marks.

It is recommended to perform this repair only if you have good mechanical knowledge, as replacing the water pump requires removing the timing belt, and a simple mistake could severely damage the engine.


Updated on 3 February 2026 by ScegliAuto


Related tutorials

Fuel Pump Replacement on Audi A6
Fuel Pump Replacement on Audi A6
Audi A6 (1997-2004 / MK 2, C5) Turn off the car and disconnect the battery by removing the terminals. On this model, the fuel pump is located under the rear seats. Remove the seats…
How to Remove the Diesel Fuel Float from an Audi A6
How to Remove the Diesel Fuel Float from an Audi A6
Audi A6 (2004-2012 / C6, MK 3) If the engine doesn't start, one possible cause is that fuel isn't reaching it due to a failure of the low-pressure pump: usually, you can hear its c…
Fuel Pump Replacement on Audi A6
Fuel Pump Replacement on Audi A6
Audi A6 (2004-2012 / C6, MK 3) How do you remove the fuel pump on an Audi A6? First, remove the access covers for the pump: either the rear seat cushions or the cover panel. Once a…

Other guides you may be interested in

How to Reset the AdBlue Warning Light on a Peugeot Boxer

To reset the AdBlue system on a 2018 Peugeot Boxer, follow these steps: Start the engine and ensure the vehicle is parked in a well-ventilated area. Locate the "MENU" button on the dashboard or steering wheel controls. Press and hold the "MENU" button until the menu options appear on the display. Use the arrow buttons or scroll wheel to access the "Vehicle Settings" or "Settings" menu. Select the "AdBlue" or "AdBlue System" option. Look for the "Recharge" or "Reset" option in the AdBlue menu. Once you find the reset option, select it and confirm your choice when prompted. The system will be reset, and a confirmation message may appear on the display. Turn off the engine and wait a few seconds. Restart the engine and check that the AdBlue system has been reset.

Watch the video!


by ScegliAuto

More videos