Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to install the armrest under the armrest of the Audi A4 B8

Model: Audi A4 B8 - Years 2007-2016
Part: Checks and maintenance

In this video we can see how to install a LED light under the armrest of the Audi A4 B8 version: lift the armrest, and with a drill and a small drill bit make a hole at the point where we want the LED lamp to be. We will then slightly widen the hole so that the lamp holder can find its proper housing. From the back, we will have to make the electrical connections, removing the plastic partition that closes the armrest. Inside, we will already find some electrical connections, so all we have to do is strip the existing wires and connect those of the lamp, so that it only turns on when we lift the armrest.

Posted on 24 July 2025 by ScegliAuto

Video tutorial

Related tutorials

How to Remove the Rear Seat of an Audi A4
How to Remove the Rear Seat of an Audi A4
Audi A4 (2004-2008 / B7) Whether you need to install new carpet, new seat covers, install completely new seats, or perform a deep cleaning, you must remove the seats to acces…
How to Install the Rear Wiper Motor on Audi A4 B7
How to Install the Rear Wiper Motor on Audi A4 B7
Audi A4 (2004-2008 / B7) In today's video, you will learn how to install the rear wiper motor on an Audi A4 B7. First, position the new wiper motor on the trunk lid, where th…
How to remove the rear seat of the Audi A4
How to remove the rear seat of the Audi A4
Audi A4 (2007-2016 / B8) The removal of the rear seat or rear bench of an Audi A4 vehicle follows a very simple procedure, which can be carried out independently thanks to ou…

    Frequently Asked Questions

    • A4 2007-2016 - How does the navigation system of my Audi A4 work? Read answer
    • A4 2004-2008 - Where is the AUX cable socket on the Audi A4? Read answer

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos