Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to reset the brake pad wear service light on the Audi Q5.

Model: Audi Q5 MK 1, 8R - Years: 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2015, 2016, 2017
Part: Checks and maintenance

See other generations:
Video tutorial

In this guide, we will see the instructions that will allow us to reset the brake pad wear service light on the Audi Q5. First, we lift the vehicle and begin to disassemble and remove the front wheel; then we disconnect the electrical connector of the brake pad wear sensor, and proceed to replace the old pads with the new original ones.

At this point, we perform the same operation on the other side, replacing the brake pads; we reconnect the wear sensors, and then verify the actual reset of the wear light.


Posted on 23 December 2025 by ScegliAuto


Related tutorials

Resetting the Brake Pad Wear Light on the Audi Q5
Resetting the Brake Pad Wear Light on the Audi Q5
Audi Q5 (2008-2017 / MK 1, 8R) In this brief and simple guide, learn how to reset the brake pad wear light on the Audi Q5 by following the instructions below. First, get inside the…
How to Replace the Front Brake Pads on an Audi Q5
How to Replace the Front Brake Pads on an Audi Q5
Audi Q5 (2008-2017 / MK 1, 8R) In this guide, we will outline the steps to remove and replace the front brake pads on an Audi Q5 in simple steps. First, lift the vehicle and begin …
Replacing Brake Pads on Audi Q5
Replacing Brake Pads on Audi Q5
Audi Q5 (2008-2017 / MK 1, 8R) Let's replace the rear brake pads on the Audi Q5. Remove the wheel before replacing the pads. Lift the vehicle using a hydraulic jack to the desired …

How to Reset the Tyre Light on a Toyota Aygo?

To reset the tyre light on a Toyota Aygo, start by locating the reset button, which is found in the glove compartment of the front passenger side. Turn on the car and ensure that the tyres are at the correct pressure. Then, press and hold the reset button for a few seconds until the tyre light either flashes or turns off, depending on the model. Release the button and wait for the reset procedure to complete. Restart your Toyota Aygo and check if the tyre light has turned off, indicating that the reset was successful.

Watch the video!


by ScegliAuto

More videos