Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Audi A4 rear brake pads replacement

Model: Audi A4 B6 - Years 2000-2004
Part: Brake pads

In this video tutorial we will show you how to replace the rear brake disc pads of an Audi A4 B6. First we go to lift the car from the rear with a hydraulic jack and we go to disassemble the wheel by removing its bolts. Then we are going to disassemble the brake caliper: to do this we are going to unscrew the screws with wrenches of 15 and 13. At this point, remove the caliper and extract the old pads. We assemble the new ones and to put the caliper back we have to go and make the piston of the same go back to push hard: then reassemble everything!

Posted on 21 August 2020 by ScegliAuto

Video tutorial

Related tutorials

How to reset brake warning light on Audi A4 B7
How to reset brake warning light on Audi A4 B7
Audi A4 (2004-2008 / B7) In today's video tutorial we will see a solution on how to reset the brake pad wear warning light on an Audi A4 B7; before carrying out the operation…
Replacement of the brake pedal switch on the Audi A4.
Replacement of the brake pedal switch on the Audi A4.
Audi A4 (2004-2008 / B7) Below we will see the instructions that will allow us to disassemble and replace the rear brake pedal switch of the Audi A4. First, we get in the car…
How to replace the rear light bulbs of the Audi A4.
How to replace the rear light bulbs of the Audi A4.
Audi A4 (2007-2016 / B8) Briefly, we will see the instructions that will allow us to disassemble and replace the bulbs of the rear light of the Audi A4. First, let's open the…

Other guides you may be interested in

How to Install Roof Bars on a Fiat 500L

Learn how to fit universal roof bars on a Fiat 500L. These bars are used on vehicles with or without roof rails. Assemble the roof bar kit (as shown in the video) with bars adjusted to the width of the vehicle (measure with a tape measure). Position the brackets at both ends of the doors on the vehicle's original roof rails. Once the anchoring bracket width is set, tighten the bolts with a butterfly nut (if a lock is present) until fully secured to the roof rails. Fit safety caps on both sides.

Watch the video!


by ScegliAuto

More videos