Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Remove Front Headlights from Audi A6

Model: Audi A6 MK 2, C5 - Years: 1997, 1998, 1999, 2000, 2001, 2002, 2003, 2004
Part: Headlight

See other generations:
Video tutorial

To replace the front headlight assembly on the Audi A6, stabilize and secure your vehicle (for example, on a lift or securely immobilized) to perform the maintenance operation without risking the operator's safety. At this point, open the hood of the engine compartment and remove, using a suitable wrench, three screws from the upper edge of the headlight and one from the lower part inside the engine compartment (after removing part of the air duct - proceed as shown in the images - that obstructs the operation).

Now, you can pull the headlight assembly out of its housing, being careful to disconnect the electrical supply. Remove all the bulbs and install them into the new headlight assembly, and then you can mount the new assembly into its housing.

The steps to follow are the same as before, but you need to proceed in reverse.


Updated on 10 April 2026 by ScegliAuto


Related tutorials

How to Remove the Headlights of the Audi A6
How to Remove the Headlights of the Audi A6
Audi A6 (2004-2012 / C6, MK 3) If you need to remove the headlights for any reason, first know that you must remove the front bumper. Once this procedure is complete, disconnect th…
Maintenance of Your Car's Headlight
Maintenance of Your Car's Headlight
Audi A6 (1997-2004 / MK 2, C5) The headlights of your car are very important for safe driving, so it is crucial that they are always in perfect condition. This guide shows how to r…
How to Remove the Tail Lights of the Audi A6
How to Remove the Tail Lights of the Audi A6
Audi A6 (2011-2018 / C7, MK 4) Let's see how to remove the tail lights of the Audi A6 without taking off the rear bumper. Remove the inner panel of the trunk near the light: find t…

How to Reset the Tyre Pressure Warning Light on the Jeep Renegade?

To reset the tyre pressure warning light on the Jeep Renegade, inflate the tyres until they reach the recommended pressure: this value is indicated on the sticker attached to the driver’s door pillar. Once the tyres are properly inflated, navigate through the menu that appears on the instrument cluster until you find the tyre pressure option. At this point, press and hold the OK button on the right side of the steering wheel to make the warning light disappear.

Watch the video!


by ScegliAuto

More videos