Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Instructions for Removing Airbag Control Unit Audi A4 B6-B7

Model: Audi A4 B7 - Years 2004-2008

In this video tutorial, you will see the main instructions to access and remove the airbag control unit of an Audi A4 B6-B7. First, locate the control unit, which is under the parking brake lever: then remove the plastic from the center console to access it. At this point, remove the control unit by using a socket wrench to take out the mounting screws on the sides, and then disconnect the electrical connector of the control unit. Finally, remove it and, if necessary, replace it with a new one!

Updated on 13 April 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacement of the ECU (Engine Control Unit) of the Audi A4
Replacement of the ECU (Engine Control Unit) of the Audi A4
Audi A4 (2000-2004 / B6) In this guide, we will see the main instructions that will allow us to disassemble and replace the ECU (Electronic Control Unit) of the Audi A4. Firs…
Instructions for Removing the Ignition Cylinder on Audi A4 B6
Audi A4 (2000-2004 / B6) In this video tutorial, you will see the main instructions for removing and replacing the ignition cylinder of an Audi A4 B6. First, get inside the c…
How to Disable the Passenger Airbag on the Audi A4
How to Disable the Passenger Airbag on the Audi A4
Audi A4 (2007-2016 / B8) If you need to place a child seat in the passenger seat, you must disable the airbag to prevent serious injury in the event of a collision. To disabl…

Other guides you may be interested in

    Frequently Asked Questions

    • A4 2004-2008 - How much does it cost to change ownership of an Audi A4 1.9 TDI? Read answer

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos