Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Instructions for Removing the Ignition Cylinder on Audi A4 B6

Model: Audi A4 B6 - Years 2000-2004

In this video tutorial, you will see the main instructions for removing and replacing the ignition cylinder of an Audi A4 B6. First, get inside the car and remove the screws from the plastic cover located under the steering wheel. Then, remove the additional screws found under the steering wheel using a Torx wrench. At this point, remove the airbag and disconnect its electrical connector located at the back. Also, remove the center nut of the steering wheel using a socket wrench to take off the steering wheel itself. Next, remove the ignition switch by moving the wiring aside.

Updated on 13 April 2026 by ScegliAuto

This video is currently unavailable

Related tutorials

Removing Audi A4 B7 Glove Box Lock and Handle
Removing Audi A4 B7 Glove Box Lock and Handle
Audi A4 (2004-2008 / B7) Today, we will see the main instructions for removing the handle and lock of the glove box of an Audi A4 B7. First, get in the vehicle and open the g…
Removing Spark Plugs on Audi A4 Engine
Removing Spark Plugs on Audi A4 Engine
Audi A4 (2000-2004 / B6) Remove the damaged spark plugs from the Audi A4. Here’s how to do it. Unlock the hood release lever located on the lower left of the dashboard and li…
How to Reset the Door Lock Module of the Audi A4
How to Reset the Door Lock Module of the Audi A4
Audi A4 (2004-2008 / B7) In today's tutorial video, we will go over the main instructions to reset the remote control and door lock module of the Audi A4. First, take your re…

Other guides you may be interested in

    Frequently Asked Questions

    • A4 2004-2008 - How much does it cost to change ownership of an Audi A4 1.9 TDI? Read answer

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos