Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Rear light bulb replacement on Audi A2

Model: Audi A2 MK 1 - Years 1999-2005
Part: Tail light bulb

Open the boot lid and remove, by hand, the side plastic on the inside and on the side, therefore behind the headlight concerned. This will be enough to have access to the rear part of the light: therefore disconnect the connector and remove the white plastic by pulling it by hand. VoilÃ! Already done! In fact, the various bulbs (low beam, brake, arrow) are fixed on this plastic, which means that once the support is removed you will have easy access to each light, being able to replace the bulb concerned. Replace the burnt out light and proceed with reassembly.

Posted on 10 January 2022 by ScegliAuto

Video tutorial

Related tutorials

How to replace the headlight bulb on an Audi A2
How to replace the headlight bulb on an Audi A2
Audi A2 (1999-2005 / MK 1) Before starting, we will have to disassemble and remove the front hood of our Audi A2. Let's start by unscrewing and removing the screws that secure …
How to disassemble the headlights in the Audi A2?
How to disassemble the headlights in the Audi A2?
Audi A2 (1999-2005 / MK 1) In this tutorial we can see how to disassemble the headlights in the Audi A2, a very simple operation. To do this, we will only need a Torx T30 key. …
How to replace the headlight bulb on the Audi A2
How to replace the headlight bulb on the Audi A2
Audi A2 (1999-2005 / MK 1) In today's video we will see the steps that will allow us to disassemble and replace the headlight bulb on an Audi A2. First of all we open the bonne…

Other guides you may be interested in

How to Replace the Lift Supports on a Porsche 911

How to remove and replace the lift supports for the hood on a Porsche 911? Let's see how to replace them in this video: Lift the hood and secure it. Use a screwdriver or metal lever to detach the clips that hold the lift support at both ends (or unscrew the mounting pins). Install the new part onto the sheet metal of the front trunk, securing the lift support with the clips/pins. Proceed in the same manner for the removal/installation of the opposite lift support. Finally, test the gas springs installed earlier.

Watch the video!


by ScegliAuto

More videos