Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Audi
    3. :
  3. Q5
    4. : Replacing the Xenon low beam of the Audi Q5

Audi Q5 - Video tutorial

Model: Audi Q5 8R, MK 1 - Years 2008-2017
Part: Headlight bulb
Operation: Replacing the Xenon low beam of the Audi Q5

The video shows how to replace the Xenon low beam lamp on the Audi Q5. It is not a difficult operation that can be done on your own in just a few steps. Disconnect the battery before proceeding with the repair. Remove the plastic clamping elements by levering them with a screwdriver. Remove the plastic cover. Unscrew the fastening screws of the headlight with a 10 mm joint wrench. Disconnect the connector from the headlight. Remove the inner cover of the headlight and unscrew the bulb. Carry out the replacement and then proceed with the assembly operations, as described above, but in reverse.


Posted on 30 March 2024 by ScegliAuto



How to replace a headlight bulb on Audi Q5
Audi Q5 (2008-2017 / 8R, MK 1) In this video tutorial we will see how to remove and replace the headlight bulb on a first generation Audi Q5, in this case a xenon bulb. First of al
How to replace the remote control battery of the Audi Q5?
Audi Q5 (2017-2024 / 80A, MK 2) Replacing the low battery of the remote control of the Audi Q5 is a very simple operation, let's see how to proceed in this tutorial. To do this we d
How to remove the AdBlue warning light on the Audi Q5?
Audi Q5 (2017-2024 / 80A, MK 2) If the AdBlue warning light comes on in our Audi Q5, it means that the pollution liquid has reached a too low level and, therefore, it needs to be to

Fiat Ducato 2.8 JTD gearbox oil replacement

Let's see in this guide the main steps to be able to change the transmission oil of the second series Fiat Ducato, with 2.8 JTD engine. First of all we lift the car and go to locate the gear oil vent bolt, which we find near the transmission; we use a hex wrench to unscrew it, letting it drain the old oil in a container for about ten minutes. At this point we open the bonnet and remove the air intake sleeve, so as to be able to access the gearbox oil filling hole; then we fill up to the maximum level!

Watch the video!


by ScegliAuto

More videos