Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Audi
    3. :
  3. Q7
    4. : Front indicator bulb replacement

Audi Q7 - Video tutorial

Model: Audi Q7 4L, MK 1 - Years 2006-2015
Part: Light bulb
Operation: Front indicator bulb replacement

In order to replace the front indicator light, located inside the bumper, the indicator light must be removed from the bumper: start by removing the plastic grille that acts as a conveyor for the air applied immediately under the indicator light by pulling it forward; in this way you can access the fixing screws of the light (25 torx) and just unscrew it to remove the indicator light from its seat and be able to unhook the lamp holder; then replace the bulb (bayonet coupling) and proceed backwards for reassembly; it is suggested to replace both bulbs and not just one.


Posted on 4 September 2023 by ScegliAuto



License plate light bulb replacement
Audi Q7 (2006-2015 / 4L, MK 1) To replace the license plate light bulb, open the rear hood and hold it up to unscrew the fixing screw of the small ceiling light that houses the bul
Audi Q7 rear light bulb replacement
Audi Q7 (2006-2015 / 4L, MK 1) In this video tutorial we will see how to remove and replace the rear light bulb of an Audi Q7, in the simple steps illustrated below. First we go to
How to reset the tire indicator light on the Audi Q7?
Audi Q7 (2015-2024 / 4M, MK 2) In this tutorial, we can see how to reset the tire indicator light in the Audi Q7, an extremely simple and fast operation, to be done only after rest

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos