Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
In this tutorial, see how to replace the rear brake pads on the Benelli Imperiale 400, a very simple and quick operation. First, position yourself in front of the brake in question, then using both a 12mm and a 17mm spanner, unscrew the lower fixing bolt of the caliper. Next, lift the caliper, separate it from the disc, and remove the old pads. Now, clean any dirt residue present, fit the new parts, and reassemble everything following the exact reverse procedure.

Updated on 15 September 2026 by ScegliAuto

Video tutorial

Related tutorials

How do you replace the front brake pads of the Benelli Imperiale 400?
How do you replace the front brake pads of the Benelli Imperiale 400?
Imperiale 400 It will be possible to replace the front brake pads of the Benelli Imperiale 400 by loosening the screws that secure the brake caliper to its housing…
How to Replace the Rear Brake Pads on the Benelli Imperiale 400?
How to Replace the Rear Brake Pads on the Benelli Imperiale 400?
Imperiale 400 To replace the rear brake pads on the Benelli Imperiale 400, loosen the screws that secure the brake caliper to the corresponding disc: once these sc…
How do you replace the rear brake pads of the Benelli Imperiale 400?
How do you replace the rear brake pads of the Benelli Imperiale 400?
Imperiale 400 To replace the rear brake pads of the Benelli Imperiale 400, you need to loosen the screws that secure the caliper to the corresponding disc so that …

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos