Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
Start by sitting on the seat of your TM Racing 125. Next, open the fuel tap. Then, insert the key into the ignition switch and turn it fully clockwise. After this, pull out the ignition lever located on the right side of the engine block and the brake lever. Once the ignition lever is out, repeatedly press the ignition lever with your foot until the engine starts. When it is running, you can close the ignition lever, and the procedure will be complete.

Updated on 12 May 2026 by ScegliAuto

Video tutorial

Related tutorials

Carburettor Adjustment for a Beta 50rr
Carburettor Adjustment for a Beta 50rr
Beta 50 Today, we will give you some tips for adjusting the carburettor of a Beta 50rr. First, check the colour of the spark plug to determine if your carbur…
How to Change the Gear Oil on a Beta 50 RR
How to Change the Gear Oil on a Beta 50 RR
Beta 50 This guide will show you how to change the transmission oil on a Beta 50 RR, following the instructions below. First, place the bike on a stand and w…
How to Dismantle the Fairing of a Beta 50
How to Dismantle the Fairing of a Beta 50
Beta 50 To dismantle the fairing of your Beta 50, first remove the seat by unscrewing the appropriate screw located at the rear of the seat. Use a ratchet sp…

How to Replace the Front Brake Pads on a Yamaha MT-125

Follow these steps to remove and replace the front brake pads on the Yamaha MT-125. First, place the motorcycle on a stand and begin unscrewing the bolts securing the front brake caliper to remove it from the disc. Next, remove the brake pads inside by pressing the piston to retract it, as shown in the video. Clean the caliper of any residual dirt, then install the new high-quality pads; reassemble the braking system!

Watch the video!


by ScegliAuto

More videos