Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to disassemble the cardan transmission of the BMW R 1200 GS

Model: Bmw R 1200 Gs
Part: Drivetrain

Video tutorial

In this guide, we will see the information that will allow us to disassemble and overhaul (or replace) the shaft drive of the BMW R 1200 GS. First, let's put the motorcycle on the center stand and begin to disassemble and remove the rear wheel; then we will disconnect the main joint of the shaft from the gearbox, as shown in the video.

At this point, we slide the shaft joint out from the rear, performing its overhaul or replacement; we reassemble and properly lubricate the shaft joint, replacing the boot between the shaft and transmission if necessary, following the video tutorial to the end!


Posted on 11 January 2026 by ScegliAuto


Related tutorials

How to Remove the Final Drive from a BMW R 1200 GS?
How to Remove the Final Drive from a BMW R 1200 GS?
R 1200 Gs To remove the final drive from a BMW R 1200 GS, loosen the bolts securing the exhaust so it can be removed along with the rear wheel. The rear wheel …
How to Replace the Clutch on a BMW R 1200 GS (2005)
How to Replace the Clutch on a BMW R 1200 GS (2005)
R 1200 Gs In today's video tutorial, you will learn how to disassemble and replace the clutch discs on a 2005 BMW R 1200 GS motorcycle. First, place your motor…
How to Replace the Clutch on a BMW R 1200 GS?
How to Replace the Clutch on a BMW R 1200 GS?
R 1200 Gs To replace the clutch on a BMW R 1200 GS, loosen the bolts securing the engine block and transmission to their housing, located at the central lower …

How to Replace the Air Filter on the Piaggio SKR 125

To replace the air filter on the Piaggio SKR 125, loosen the bolts securing the filter box located on the left side of the bike, near the rear wheel. Once the cover is removed, you can access the filter underneath and pull it out from its housing. After removal, insert the new replacement part, close the filter box, and secure the cover with the bolts. After installation, start the engine to check that everything is functioning correctly.

Watch the video!


by ScegliAuto

More videos