Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Remove the A-Pillar Trim on BMW 3 Series

Model: BMW Serie 3 E46 - Years 1998-2006
Part: Checks and maintenance

In this video, see how to remove the front and rear trim and the seat belt retractor on a BMW 3 Series. Gather various trim tools, screwdrivers, and wrenches or sockets. Use a plastic trim tool to remove the upper and lower side trim where the seat belt retractor is located, then open the plastic cap on the front seat. Use a socket wrench to remove the fastening bolt located in the front seat of the seat belt, and remove the seat belt retractor along with its mounting bracket. Finally, install the new seat belt cover panel with the necessary parts for assembly.

Updated on 1 March 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacing the Pillars and Interior Trim of the BMW 3 Series
Replacing the Pillars and Interior Trim of the BMW 3 Series
BMW Serie 3 (1998-2006 / E46) This guide provides instructions on how to remove and replace the pillars and repair the interior fabric trim of the BMW 3 Series. First, get inside …
Removing the Door Pillar of the BMW 3 Series
Removing the Door Pillar of the BMW 3 Series
BMW Serie 3 (1998-2006 / E46) Discover how to remove the front door pillar of the BMW 3 Series with this simple guide, following these easy steps. First, open the front door and s…
Instructions for Removing the Rear Glass
Instructions for Removing the Rear Glass
BMW Serie 3 (1998-2006 / E46) To remove the rear glass of this coupe version, start by pulling off the weatherstrip from the front door, then unscrew the mounting screws of the ch…

    Frequently Asked Questions

    • Serie 3 2012-2019 - How much does a service cost for the BMW 3 Series? Read answer
    • Serie 3 2005-2013 - Why is the on-board computer of the BMW 3 Series slow to start up? Read answer

How to reset the tyre pressure warning light on the Suzuki Jimny?

To reset the tyre pressure warning light on the Suzuki Jimny, first inflate the tyres to the pressure value indicated on the corresponding sticker: this is located at the bottom of the driver's door pillar. Once the tyres are inflated, insert the ignition key and turn on the instrument panel: select the screen that indicates the tyre pressures, checking that the values change. After a few seconds, the tyre pressure warning light will automatically turn off.

Watch the video!


by ScegliAuto

More videos