Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Install the Backup Camera in the Trunk Lid of a BMW 3 Series

Model: BMW Serie 3 F30, F31 - Years 2012-2019
Part: Checks and maintenance

Let's see how to install the backup camera in the trunk lid of a BMW 3 Series. First, open the trunk lid of the car, then remove the interior trim on the trunk lid by unscrewing the screws on the plastic trim with a screwdriver. Disconnect the license plate light from the trunk and remove the interior trim of the trunk lid using a pry tool (located between the frame metal and the plastic trim). Run the wiring from the camera to the dashboard (connect the power cables to the head unit that supports the camera) of the car. For reassembly, proceed in reverse order.

Updated on 11 March 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Install the Backup Camera on a BMW 3 Series?
How to Install the Backup Camera on a BMW 3 Series?
BMW Serie 3 (2005-2013 / E91, E90, E92) To install the backup camera on a BMW 3 Series, open the rear hatch by unscrewing the screws that secure the corresponding panel inside. Once the pan…
How to Install a Backup Camera on BMW 3 Series E46
How to Install a Backup Camera on BMW 3 Series E46
BMW Serie 3 (1998-2006 / E46) In this video tutorial, you will see the instructions to install a generic backup camera on a BMW 3 Series E46, following these steps. First, open th…
How to Install a Camera on BMW 3 Series
How to Install a Camera on BMW 3 Series
BMW Serie 3 (2005-2013 / E91, E90, E92) Let's see how to install the camera (where the license plate light is located) in the trunk of a BMW 3 Series. First, open the trunk of the car, then…

Other guides you may be interested in

    Frequently Asked Questions

    • Serie 3 2012-2019 - How much does a service cost for the BMW 3 Series? Read answer
    • Serie 3 2005-2013 - Why is the on-board computer of the BMW 3 Series slow to start up? Read answer

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos