Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. BMW
    3. :
  3. X6
    4. : How to remove the fog light of a BMW X6

BMW X6 - Video tutorial

Model: BMW X6 MK 1, E71 - Years 2007-2014
Part: Fog lights
Operation: How to remove the fog light of a BMW X6

Let's see in this video how to remove the fog light with attached bulb on a BMW X6. Let's get ready to remove the side fog light placed on the bumper. Using a suitable screwdriver, we release the clips for tightening the plastic of the spotlight, then remove the same from the bumper with a lever. Once the plastic has been removed, unscrew the screws on the sides of the spotlight and extract it from the car's bumper (disconnect the power cable). We assemble the new piece with a new bulb attached (same size and voltage). We test the correct functioning of the same after replacement.


Posted on 24 November 2023 by ScegliAuto



How to reset the tire pressure warning light on BMW X6
BMW X6 (2014-2019 / F16, MK 2) Let's see in this short and simple video how to go to reset the tire pressure warning light (TPMS) on the second series BMW X6; before carrying out t
Guide to replace the headlights on the BMW X6 E71
BMW X6 (2007-2014 / MK 1, E71) In this video tutorial we will see how to remove and replace the headlight on the BMW X6 E71, first generation, by following the instructions below.
How to replace the key battery of a BMW X6
BMW X6 (2007-2014 / MK 1, E71) We start by pressing the button located in the lower section of the electric key of our BMW X6, and then extracting the internal physical key. After

Fiat Ducato 2.8 JTD gearbox oil replacement

Let's see in this guide the main steps to be able to change the transmission oil of the second series Fiat Ducato, with 2.8 JTD engine. First of all we lift the car and go to locate the gear oil vent bolt, which we find near the transmission; we use a hex wrench to unscrew it, letting it drain the old oil in a container for about ten minutes. At this point we open the bonnet and remove the air intake sleeve, so as to be able to access the gearbox oil filling hole; then we fill up to the maximum level!

Watch the video!


by ScegliAuto

More videos