Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Lift Supports of a BMW 3 Series Trunk

Model: BMW Serie 3 E91, E90, E92 - Years 2005-2013
Part: Hydraulic pistons

How do you replace the gas lift supports of the rear trunk? Let's see in this video how to replace the parts on a BMW 3 Series. Lift the trunk and secure it with a prop rod; use a screwdriver to detach the metal clips that hold the worn lift support at both ends (or unscrew the retaining pins). Install the new part on the vehicle and secure the lift support with the metal clips. Follow the same procedure for removing/installing the twin lift support. Finally, test the installed gas lift supports (open and close the trunk).

Updated on 13 March 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Gas Springs on the Trunk of a BMW 3 Series
How to Replace the Gas Springs on the Trunk of a BMW 3 Series
BMW Serie 3 (1998-2006 / E46) Let's see how to replace the gas springs on the trunk of a BMW 3 Series. This is a very simple operation, follow these steps: lift the trunk of the c…
How to Replace the Trunk Lock on the BMW 3 Series?
How to Replace the Trunk Lock on the BMW 3 Series?
BMW Serie 3 (1990-2001 / E36) To replace the trunk lock on the BMW 3 Series, lift the trunk and remove the inner cover to access the underlying parts. Once the cover is removed, l…
How to Replace the Hood Struts on a BMW 3 Series
How to Replace the Hood Struts on a BMW 3 Series
BMW Serie 3 (2005-2013 / E91, E90, E92) How do you replace the hood struts? Let's see how to replace the gas springs mounted inside the hood of a BMW 3 Series. Lift the hood and secure it. …

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos