Do it yourself
| ||||
|
BMW Serie 5 - Video tutorial
Model: BMW Serie 5
E61, E60
- Years 2003-2010 Start with the bulbs of the front ceiling light: with a plastic one for body builders, unhook the ceiling light, first the part with the buttons and then the part with the lamp holders; disconnect the latter from the socket in order to extract the bulbs to be replaced with the led ones: remember to respect the polarity of the led bulb (if it does not turn on, exchange the polarity by turning the bulb 180Â °). Proceed in the same way to install the LED bulbs on the rear ceiling light. Proceed with the footwell lighting: unhook the bulb holder, remove the reflective screen and replace the torpedo bulb with the LED one, always remembering the polarity issue. The operation is the same for the courtesy lights in the doors: however, the bulbs are of the T5 type and not torpedo. Complete the operation by replacing the license plate lights: unclip the bulb holders and replace the torpedo bulbs.
Posted on 5 July 2023 by ScegliAuto
LED interior lighting installation
BMW Serie 5 (2010-2017 / F11, F10) Replacing the interior lights with those of the LED type will certainly give the car a more modern and captivating appearance, as well as significant
Mount the LED headlights in your car
BMW Serie 5 (1995-2003 / E39) LEDs are small, inexpensive and different colored lights, which can be switched on and off intermittently. This type of lights are an excellent solut
Replacement of interior bulbs of the BMW 5 Series
BMW Serie 5 (2010-2017 / F11, F10) Following these short and simple instructions, we will see how to disassemble and replace the interior lights of the BMW 5 Series. First of all, we g Other guides that may interest you
|
Fiat Ducato 2.8 JTD gearbox oil replacementLet's see in this guide the main steps to be able to change the transmission oil of the second series Fiat Ducato, with 2.8 JTD engine. First of all we lift the car and go to locate the gear oil vent bolt, which we find near the transmission; we use a hex wrench to unscrew it, letting it drain the old oil in a container for about ten minutes. At this point we open the bonnet and remove the air intake sleeve, so as to be able to access the gearbox oil filling hole; then we fill up to the maximum level! by ScegliAuto More videos
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.022
(c) ScegliAuto 2024 - info@scegliauto.com - Privacy Policy VAT number: IT01247470535 |