Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Check Integrity of Control Arm Bushing

Model: BMW Serie 3 E36 - Years 1990-2001
Part: Bushings

To perform this operation, lift the vehicle using a lift or appropriate ramps: avoid using solutions like the one shown in the video. To properly check the integrity of the bushing (or silent block) of the suspension control arm, it is recommended to remove it for adequate inspection from all sides: disassembly may require using a torch to heat the part connected to the bar, which often tends to seize. Once the support is removed, check that the rubber part between the outer and inner rings is completely intact and still properly bonded along the edges.

Updated on 5 February 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacing the Silent Block Bushing
Replacing the Silent Block Bushing
BMW Serie 3 (1998-2006 / E46) The failure of the silent block bushing on the suspension control arm is a common issue in BMW models, but the repair is straightforward since you ca…
How to Replace the Control Arm Support on BMW 3 Series E46
How to Replace the Control Arm Support on BMW 3 Series E46
BMW Serie 3 (1998-2006 / E46) The failure of the control arm support bushing in the front suspension (commonly known as a silent block) is a frequent issue on this car model. In t…
Replacing Suspension Arm Bushings
Replacing Suspension Arm Bushings
BMW Serie 3 (1998-2006 / E46) If the bushings of the suspension control arm are damaged, you can purchase just the replacement bushings (silent block) instead of the entire arm. T…

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos