Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Removing Rear Door Panel

Model: BMW Serie 5 E60, E61 - Years: 2003, 2004, 2005, 2006, 2007, 2008, 2009, 2010
Part: Door trim panel

See other generations:
Video tutorial

Disconnect the SRS/AIRBAG tag and remove the screw underneath; then remove the other two screws along the edge of the panel (one at the bottom and the other on the inner edge; these screws are covered by a cap that must be removed to unscrew them) and, using a plastic lever, release the clips; then pull the panel upward to detach it from the weatherstrip, disconnect the release lever cable and the power connector for the courtesy light and the airbag to completely remove it. Reverse the procedure for reinstallation.


Updated on 6 February 2026 by ScegliAuto


Related tutorials

Removing the Rear Door Panel of the BMW 5 Series
Removing the Rear Door Panel of the BMW 5 Series
BMW Serie 5 (2003-2010 / E60, E61) Today, let's go over the instructions to remove and replace the rear door panel of the BMW 5 Series. First, open the rear door of the vehicle and sta…
How to Remove the Rear Door Panel of the BMW 5 Series
How to Remove the Rear Door Panel of the BMW 5 Series
BMW Serie 5 (2010-2017 / F11, F10) Today, let's go through the procedure for removing the rear door panel of the BMW 5 Series. First, open the rear door of the vehicle and start by rem…
Removing the Rear Door Panel
Removing the Rear Door Panel
BMW Serie 5 (1995-2003 / E39) To remove the rear door panel, start by unscrewing the lock, disconnecting the window switch, and removing the protective cap over the screw inside t…

How to Reset the Tyre Pressure Warning Light on a Kia Rio?

The tyre pressure warning light displayed on the instrument cluster of the Kia Rio can be reset by inflating the tyres until they reach the recommended pressure value: this value is indicated on the sticker affixed to the driver's door pillar. Once all tyres have been inflated to the recommended pressure, turn on the ignition to check that the light has disappeared: if it is still present, it may be necessary to drive for a few miles, allowing the sensors to work and thus turning off the light.

Watch the video!


by ScegliAuto

More videos