Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Tips for Removing the Expansion Tank

Model: BMW Serie 5 E39 - Years 1995-2003
Part: Radiator

This tutorial provides some tips explaining the procedure to remove and replace the expansion tank from a BMW 5 Series. First, remove the screw that secures the tank. Next, take off the fan cover by removing the plastic clip that holds it in place. Also, remove the long plastic gasket along the edge of the cover. To remove the vent tube, loosen and remove the clamp that secures it, and pull the tube towards the expansion tank. Additionally, the tube must also be disconnected from the tank side.

Updated on 9 February 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacing the Radiator Cap
Replacing the Radiator Cap
BMW Serie 5 (1995-2003 / E39) The coolant reservoir also serves as an expansion tank; when the pressure in the radiator exceeds the spring calibration of the cap (the number on th…
Adding Antifreeze to the Engine Radiator
Adding Antifreeze to the Engine Radiator
BMW Serie 5 (1995-2003 / E39) In extremely cold temperatures, it is advisable to add antifreeze to the radiator to prevent engine damage. Mark the original position of the expansi…
Tips for Removing the Starter Motor
Tips for Removing the Starter Motor
BMW Serie 5 (1995-2003 / E39) This video provides some tips regarding the procedure for removing the starter motor from a BMW 5 Series. It particularly highlights the suitable too…

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos