Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Connect "Angel Eyes" Lights to Door Lock with Remote

Model: BMW Serie 5 E39 - Years 1995-2003
Part: Key

As you may remember, in the previous video, I showed you the installation of the "angel eyes" lights and the entire process, including the cable routing inside the engine compartment and the connection inside the fuse box. Now, if you want the lights to turn off/on when the doors close, simply take the yellow wire, which was not used previously, and extend it by routing it out through the hood release cable passage. Under the dashboard, once you locate the red wire with the blue stripe, connect the yellow wire using a splice connector.

Updated on 10 February 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacing the Headlight Bulb in ANGEL EYES
Replacing the Headlight Bulb in ANGEL EYES
BMW Serie 5 (2003-2010 / E61, E60) To replace the LED or Xenon bulbs in ANGEL EYES headlights, completely remove the front light assembly. Unscrew the retaining screws of the assembly …
Replacing Angel Eyes Front Bulbs
Replacing Angel Eyes Front Bulbs
BMW Serie 5 (1995-2003 / E39) To replace the LED or Xenon bulbs in the ANGEL EYES headlights, you must completely remove the front light assembly. Unscrew the retaining screws and…
Replacing Angel Eyes Front Bulbs and Removing Headlight
BMW Serie 5 (2003-2010 / E61, E60) To replace the LED or Xenon bulbs in the ANGEL EYES headlights, you must completely remove the front light assembly. Unscrew the retaining screws and…

Other guides you may be interested in

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos