Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Installing a Phone Mount Bracket

Model: BMW Serie 3 E92, E90, E91 - Years 2005-2013
Part: Accessory kit

If you decide to install a phone mount bracket in your car, choose a product that allows for installation without damaging the car's interior. In the past, for older car phones, brackets were usually mounted externally on the center console, leaving drill marks upon removal. Currently, there are mounts specific to the make and model of the vehicle that use existing screws for installation. In the case of the BMW 3 Series, the bracket is secured under the controls of the radio: simply disconnect the climate control buttons and the trim around the radio to attach the bracket.

Updated on 10 February 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Install a Tow Hitch on a BMW 3 Series
How to Install a Tow Hitch on a BMW 3 Series
BMW Serie 3 (2012-2019 / F31, F30) Installing a tow hitch must be done at an authorized shop since, along with the hitch's compliance certificate, you need to attach the installation r…
Replacing Rear Brake Discs and Pads
Replacing Rear Brake Discs and Pads
BMW Serie 3 (2005-2013 / E92, E90, E91) To replace the rear brake discs and pads, start by lifting the vehicle and removing the rear wheel; remove the protective caps from the caliper mount…
Replacing Sun Visor Support Bracket
Replacing Sun Visor Support Bracket
BMW Serie 3 (1998-2006 / E46) The passenger side sun visor is attached to the headliner with a hinge on the right side and a support bracket on the left. On the left side, the sun…

How to Remove the Armrest on the Centre Tunnel of a Volkswagen Golf

Let’s see how to remove the armrest on the centre tunnel of a Volkswagen Golf. Unscrew the securing screws (located inside the cup holder) with a screwdriver; use a plastic lever to pry off the cover at the rear of the centre tunnel (air vents). After removing the plastic cover, unscrew the securing bolts in the centre armrest using a socket wrench. Once this is done, pull off the tunnel and disconnect any power cables. Finally, insert the new part into the centre tunnel, and reassemble all components of the glove compartment as previously disassembled.

Watch the video!


by ScegliAuto

More videos