Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing Rear Brake Discs and Pads

Model: BMW Serie 3 E91, E90, E92 - Years 2005-2013
Part: Brake pads

To replace the rear brake discs and pads, start by lifting the vehicle and removing the rear wheel; remove the protective caps from the caliper mounting pins and remove the caliper itself, then also remove the corresponding mount and retract the piston by pushing it with a channel lock pliers; then unscrew the bolt that secures the disc to the hub and take it off; clean the disc seat on the hub with a wire brush, apply grease to prevent oxidation, and install the new disc after cleaning it of protective oil; before reassembling the mount, caliper, and new pads, move the wheel well liner to access the wear sensor connector and connect the new one. Complete the installation of the mount, new pads, and caliper; it is recommended to bleed the brake fluid by pressurizing the system with a special pump.

Updated on 18 February 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Change the Brake Discs and Pads on a BMW 3 Series F30
How to Change the Brake Discs and Pads on a BMW 3 Series F30
BMW Serie 3 (2012-2019 / F30, F31) In today's tutorial video, you will see how to disassemble and replace the front brake discs and pads on a BMW 3 Series F30 and F31, following the in…
Replacing Front Brake Discs and Pads on BMW 3 Series
Replacing Front Brake Discs and Pads on BMW 3 Series
BMW Serie 3 (2005-2013 / E91, E90, E92) Learn how to change the brake discs and pads on the BMW 3 Series. Place the car on a lift and raise it to a working height. Remove the front wheel. U…
Replacing Brake Rotors and Brake Pads
Replacing Brake Rotors and Brake Pads
BMW Serie 3 (1990-2001 / E36) Remove the brake caliper using a ratchet wrench by unscrewing the two rear bolts. Disassemble the caliper bracket in the same way. Using a wrench, un…

Other guides you may be interested in

How to Bleed the Clutch on a Renault Clio?

To bleed the clutch on a Renault Clio, open the bonnet to access the components located in the engine bay: here, you will need to undo the screws that secure the battery in its housing, the intake manifold, and the coolant reservoir. This will allow you to locate the pipe through which the brake fluid flows: by inserting the other end of the pipe into a container, you can press the clutch pedal to expel all the fluid until it fills the container.

Watch the video!


by ScegliAuto

More videos