Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Removing the Window Regulator Mechanism

Model: BMW Serie 3 E46 - Years 1998-2006
Part: Power window motor

To remove the window regulator mechanism, first, you need to take off the door panel by removing the corresponding mounting screws (under the handle cover) and the push clips along the edges; then lower the glass to access the glass mounting clips and loosen the mounting pins to extract the glass; at this point, remove the mounting pins of the window regulator mechanism, disconnect the motor power connector, and pull the mechanism out of the door; then proceed in reverse for installation.

Updated on 14 February 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacement of the rear window regulator mechanism of the BMW 3 Series.
Replacement of the rear window regulator mechanism of the BMW 3 Series.
BMW Serie 3 (2005-2013 / E92, E90, E91) The following steps will show us how to disassemble and replace the rear window regulator mechanism of the BMW 3 Series. First, we open the rear door…
Removing the Window Regulator Mechanism
Removing the Window Regulator Mechanism
BMW Serie 3 (1998-2006 / E46) To install the new window regulator mechanism, first remove the door panel and the underlying soundproofing material: to remove the panel, take off t…
Instructions for Removing the Window Regulator Motor
Instructions for Removing the Window Regulator Motor
BMW Serie 3 (1998-2006 / E46) To remove the window regulator mechanism on this convertible model, you must first remove the inner trim panel and the outer molding. Once the moldin…

How to Install Roof Bars on a Fiat 500X

Learn how to equip your car with universal roof bars. Universal roof bars are used on cars with and without roof rails (fixed bars secured to the car roof). Install the roof bar kit as shown in the video with the bars calibrated according to the width of the car. Position the brackets at both ends of the doors on the car's original roof rails. Once the width of the anchoring brackets is adjusted, tighten the bolts with the butterfly nut (if a lock is present) until fully secured to the roof rails. Finally, apply the safety caps on your Fiat.

Watch the video!


by ScegliAuto

More videos