Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing the Serpentine Belt

Model: BMW Serie 5 E39 - Years: 1995, 1996, 1997, 1998, 1999, 2000, 2001, 2002, 2003
Part: V-belt

See other generations:
Video tutorial

The car model in question is equipped with two auxiliary belts, each with its own tensioner: when replacing these belts, it is always advisable to also replace the corresponding tensioners. Start with the pneumatic tensioner accessible from the engine compartment: loosen the tensioner to slide off the belt and remove the fastening pins to take it out along with its support and pulley.

Then replace the pneumatic damper and proceed in reverse for installation. Before inserting this belt, replace the other one, which has a tensioner accessible from the lower part of the engine compartment: replace the belt tensioner pulley and the belt itself, then insert the other belt and tension it by adjusting the appropriate tensioner.


Updated on 16 February 2026 by ScegliAuto


Related tutorials

How to Replace the Serpentine Belt on a BMW 3 Series?
How to Replace the Serpentine Belt on a BMW 3 Series?
BMW Serie 5 (2010-2017 / F11, F10) To replace the serpentine belt on a BMW 3 Series, open the hood to access the front of the engine block, where the belt is located. To remove it, loo…
How to Change the Alternator Belt on a BMW 5 Series
How to Change the Alternator Belt on a BMW 5 Series
BMW Serie 5 (2003-2010 / E60, E61) This guide outlines the steps to remove and replace the alternator belt on a BMW 5 Series, following the instructions below. First, open the hood of …
Replacing the Tensioner for the Serpentine Belt
Replacing the Tensioner for the Serpentine Belt
BMW Serie 5 (2003-2010 / E60, E61) Open the hood and locate the serpentine belt in front of the engine, behind the radiator. Choose the appropriate wrench, insert it into the tensioner…

How to Reset the Tyre Pressure Warning Light on the Jeep Renegade?

To reset the tyre pressure warning light on the Jeep Renegade, inflate the tyres until they reach the recommended pressure: this value is indicated on the sticker attached to the driver’s door pillar. Once the tyres are properly inflated, navigate through the menu that appears on the instrument cluster until you find the tyre pressure option. At this point, press and hold the OK button on the right side of the steering wheel to make the warning light disappear.

Watch the video!


by ScegliAuto

More videos