Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. BMW
    3. :
  3. Serie 3
    4. : How to replace the cabin air filter of a BMW 3 Series E90.

BMW Serie 3 - Video tutorial

Model: BMW Serie 3 E92, E91, E90 - Years 2005-2013
Part: Cabin air filter
Operation: How to replace the cabin air filter of a BMW 3 Series E90.

In this video tutorial, we are shown how to replace the cabin air filter of a BMW 3 Series E90. First, we open the engine compartment and secure the hood so that it stays open. Using an 8mm socket wrench, we remove the screws of the filter cover located on the windshield, under the wipers. We then proceed to extract the filter by releasing the levers that hold it in place on the cover housing. We then insert the new filter, taking care to properly engage the locking levers to ensure that it adheres well. We reinsert the filter into its designated slot and screw back in the bolts that were previously removed.


Posted on 25 June 2023 by ScegliAuto

Other guides that may interest you

    Frequently Asked Questions

    • Serie 3 2005-2013 - Where is the cabin filter of the BMW E90? Read Answer
    • Serie 3 1990-2001 - How much does the BMW E46 cabin air filter cost? Read Answer
    • Serie 3 2005-2013 - Where is the cabin filter of the BMW 320 F30-F31? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos