Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Car Radio Amplifier Replacement

Model: BMW Serie 3 E91, E90, E92 - Years 2005-2013
Part: Speaker

If raising the volume of the car radio results in distorted sound from the speakers, the amplifier may be damaged and needs to be replaced or repaired. In any case, proceed with its removal. The amplifier is located in the trunk, near the left rear light (driver's side), under the cargo floor. Open the hood, remove the cargo floor cover and the side carpet to access the amplifier. Disconnect the connector and remove it along with its supporting brackets, which should be attached to the new one.

Updated on 19 February 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Car Radio on BMW E46
How to Replace the Car Radio on BMW E46
BMW Serie 3 (1998-2006 / E46) Want to remove and replace the car radio in your BMW? Let's see how to take it out from the dashboard plastics. Remove the trim above the dashboard: …
How to Install a Subwoofer in a BMW 328i E90
How to Install a Subwoofer in a BMW 328i E90
BMW Serie 3 (2005-2013 / E91, E90, E92) This guide shows how to install a subwoofer in a BMW 328i E90. To perform the operation, you need to connect an audio amplifier and a signal converte…
How to dismantle the car radio of the BMW Series 3.
How to dismantle the car radio of the BMW Series 3.
BMW Serie 3 (2005-2013 / E91, E90, E92) The instructions provided in this guide will allow us to remove and replace the stock radio of the BMW 3 Series. First, we get inside the vehicle and…

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos