Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing the Silent Block Bushing

Model: BMW Serie 3 E46 - Years: 1998, 1999, 2000, 2001, 2002, 2003, 2004, 2005, 2006
Part: Control arm

See other generations:
Video tutorial

The failure of the silent block bushing on the suspension control arm is a common issue in BMW models, but the repair is straightforward since you can replace the bushing without removing the entire control arm. It is also easy and economical to find the replacement part in the aftermarket.

Lift the vehicle and remove the splash guard for easier access to the bushing housing.

Then, unscrew the two mounting bolts of the bushing and remove it, extracting the rubber part as well. Apply grease to the new bushing to facilitate installation on the control arm and tighten the two mounting bolts.


Updated on 19 February 2026 by ScegliAuto


Related tutorials

Replacing the Silent Block of the Suspension Control Arm
Replacing the Silent Block of the Suspension Control Arm
BMW Serie 3 (1998-2006 / E46) To perform this maintenance, it is advisable to lift the vehicle on a lift, but it can also be sufficient to place it on appropriate jack stands; the…
Replacing Suspension Arm Bushings
Replacing Suspension Arm Bushings
BMW Serie 3 (1998-2006 / E46) If the bushings of the suspension control arm are damaged, you can purchase just the replacement bushings (silent block) instead of the entire arm. T…
Replacing Rear Suspension Control Arm Bushing
Replacing Rear Suspension Control Arm Bushing
BMW Serie 3 (1998-2006 / E46) Lift the vehicle on a lift and remove the wheel corresponding to the suspension you need to work on: you can then access the control arm of the suspe…

How to Reset the Tyre Pressure Warning Light on a Kia Rio?

The tyre pressure warning light displayed on the instrument cluster of the Kia Rio can be reset by inflating the tyres until they reach the recommended pressure value: this value is indicated on the sticker affixed to the driver's door pillar. Once all tyres have been inflated to the recommended pressure, turn on the ignition to check that the light has disappeared: if it is still present, it may be necessary to drive for a few miles, allowing the sensors to work and thus turning off the light.

Watch the video!


by ScegliAuto

More videos