Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Disassembly and Replacement of the Cabin Fan in a BMW 5 Series

Model: BMW Serie 5 E61, E60 - Years 2003-2010
Part: Blower motor

Here are step-by-step instructions to disassemble and replace the cabin fan in your BMW 5 Series. First, get inside the vehicle and begin removing the entire center console and the cover of the center tunnel. To do this, remove the radio and climate control knobs, disconnecting the electrical connectors found on the back, then remove the plastic cover of the center tunnel by unscrewing all the screws. At this point, you will be able to access and remove the fan by unscrewing the screws and disconnecting its electrical connector. Finally, install the new cabin fan!

Updated on 16 August 2026 by ScegliAuto

Video tutorial

Related tutorials

Where are the fuses located in the BMW 5 Series?
Where are the fuses located in the BMW 5 Series?
BMW Serie 5 (2010-2017 / F11, F10) All fuses in the BMW 5 Series are located inside the designated fuse boxes installed in the vehicle: in this car model, you can find two fuse boxes. …
Removing the Door Panel on BMW 5 Series
Removing the Door Panel on BMW 5 Series
BMW Serie 5 (2003-2010 / E61, E60) Remove the left front door of a BMW 5 Series to replace it with a new one. Disconnect the battery terminals located in the engine compartment. Using …
Guide to Removing the AdBlue Tank from the BMW 5 Series
Guide to Removing the AdBlue Tank from the BMW 5 Series
BMW Serie 5 (2010-2017 / F11, F10) Today, let's go through the main steps for removing and replacing the AdBlue tank from the BMW 5 Series, following the instructions below. First, lif…

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos