Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. BMW
    3. :
  3. Serie 3
    4. : Replacement of front bumper guides

BMW Serie 3 - Video tutorial

Model: BMW Serie 3 E92, E91, E90 - Years 2005-2013
Part: Bodywork
Operation: Replacement of front bumper guides

Open and raise the hood and on the edge of the headlights there is a lever to move to remove the small panels under both headlights, now go and remove the clips that lock the inner fender above the wheel, if necessary also remove the wheel to work more comfortably, now also remove the bolts that block the front bumper to the fender, disconnect all the connectors, now go and remove the bolts on the part behind the license plate on the front bumper. Now with a slight force pull the bumper outwards which will free itself from the clips. Now let's change the guides by removing the clips under them. Install the new guides and reassemble everything following the steps in reverse.


Posted on 19 September 2023 by ScegliAuto

Other guides that may interest you

    Frequently Asked Questions

    • Serie 3 1998-2006 - Where can I find the paint codes for the BMW 3 Series E46? Read Answer
    • Serie 3 2005-2013 - Where is the color code on BMW 3 series? Read Answer
    • Serie 3 2005-2013 - How much does it cost to repaint a BMW 3 series? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos