Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Citroen
    3. :
  3. Xsara Picasso
    4. : Citroen Xsara Picasso diesel filter replacement

Citroen Xsara Picasso - Video tutorial

Model: Citroen Xsara Picasso MK 1 - Years 1999-2012
Part: Diesel filter
Operation: Citroen Xsara Picasso diesel filter replacement

Removing the diesel filter of a Citroen Xsara Picasso? Let's see how to do it. We lift the front hood of the car, we identify the diesel filter as in the video. With a fixed wrench we unscrew the pin that tightens the cap (we can also use a socket wrench) located above the container where the diesel filter is located. Once the filter has been removed, remove it from the car (replace it with a new filter). Finally we reassemble the filter to the attached container of the diesel filter and tighten the pin above the container cap. We connect the tubes and clamps above the filter container.


Posted on 29 November 2023 by ScegliAuto



How do you replace the diesel filter in the Citroen Xsara Picasso?
Citroen Xsara Picasso (1999-2012 / MK 1) The fuel filter of the Citroen Xsara Picasso is located in the center of the engine block, therefore at the front of the vehicle. To access it, we mu
Replacing the diesel filter on Citroen Xsara Picasso
Citroen Xsara Picasso (1999-2012 / MK 1) Working with the engine off and the handbrake on, lift the right side (passenger side) of the vehicle with a jack approximately in the middle of the
Replacement headlight bulbs on Citroen Xsara Picasso
Citroen Xsara Picasso (1999-2012 / MK 1) Are the Xsara Picasso headlight bulbs burned out and therefore need to be replaced? Let's see how they disassemble. We open the front hood by pulling

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos