Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Citroen
    3. :
  3. C3
    4. : Removing the Citroen C3 starter motor

Citroen C3 - Video tutorial

Model: Citroen C3 FN, FC - Years 2002-2009
Part: Starter motor
Operation: Removing the Citroen C3 starter motor

Today we will see the instructions that will allow us to remove the starter motor of a Citroen C3 first series. First of all, open the bonnet and disconnect the two battery terminals in advance, in order to prevent any short circuits; we lift our car and go to locate our component. So let's unscrew its fixing screws, which we find on the sides of the same, and disconnect the power supply electrical connector. We just have to follow the video to the end for the complete disassembly; apply the reverse procedure for reassembly!


Posted on 24 March 2024 by ScegliAuto

    Frequently Asked Questions

    • C3 2009-2016 - Why does the Citroen C3 not start? Read Answer
    • C3 2009-2016 - Where is the starter motor of the Citroen C3 located? Read Answer
    • C3 2002-2009 - What problems does the starter motor of the Citroà «n C3 have? Read Answer
    • C3 2009-2016 - What problems with the starter motor of the Citroen C3? Read Answer
    • C3 2016-2023 - How much does it cost to replace the starter motor on the Citroà «n C3? Read Answer
    • C3 2002-2009 - Where is the starter motor of a Citroen C3 located? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos