Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Citroen
    3. :
  3. Xsara
    4. : Where are the fuses on the Citroen Xsara

Citroen Xsara - Video tutorial

Model: Citroen Xsara MK 1 - Years 1997-2006
Part: Fuse box
Operation: Where are the fuses on the Citroen Xsara

To replace the fuses of the Citroen Xsara inside the passenger compartment we have to go to the left of the steering wheel, under the mirror adjustment there is a flap; to remove the flap just pull it, pulled the flap we find the fuse box. Once the fuse box has been opened, we find a pair of tweezers, identify the fuse relating to the device to be changed, take the tweezers, remove the fuse to be changed and note that if the jumper in the fuse is intact, the fuse does not need to be changed, otherwise if the jumper in the fuse is broken the fuse needs to be changed and therefore we take the new fuse of the same amperage and put it in place of the fuse with the broken jumper.


Posted on 29 April 2023 by ScegliAuto

Other guides that may interest you

    Frequently Asked Questions

    • Xsara 1997-2006 - Fuse diagram of the Citroen Xsara? Read Answer
    • Xsara 1997-2006 - Where is the fuse box on the Citroen Xsara Picasso located? Read Answer
    • Xsara 1997-2006 - Where is the Citroà «n Xsara fuse box located? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos